restoring a 1965 Mustang
The replacement trunk floor that I ordered came as a fully assembled piece, making it rather large and unwieldy. So much so that there was going to be no way to get it into the car without removing the tail panel. There were some areas on the tail panel that needed attention anyway so this […]
After coming to the conclusion that the quarter panels were going to need to be replaced I decided to switch gears and finish out the work in the trunk first. My thought was that while I still had the old quarter panels on (and most of the wheel wells) they would serve as useful guidelines […]
Though I had put it off as long as possible, it was finally time to cut off the lower rear section of the driver’s side quarterpanel. There were small rust spots along the seam where the section had been replaced previously, as well as some damage inside the lip of the wheelwell. I taped it […]