With the rear seat support brackets reinstalled there were only a couple small brackets preventing the back half of the interior from being able to be installed.
The first set of brackets to install were the rear seat retaining brackets. Thankfully I took pretty good measurements before removing the original floor so locating them properly wasn’t too difficult.
The brackets for the interior quarter panel pieces required so more interesting methods as I failed to get measurements for them prior to removing the original wheel houses. Thankfully I was able to install the brackets to the interior pieces and then push them into place, marking their location on the wheel houses with a silver Sharpie.
With both pairs of brackets installed the rear seat and quarter panel trim fell right into place. With the carpet it almost looked like a car again from some very specific angles.
They came right back out, of course, but it was fun to see!
Haha love the pic of you sitting in the car